This type of heat exchanger is used to heat a Swimming Pool or Spa from any Hydronic system such as an outdoor furnace. It can also be used in conjunction with an existing gas, propane or oil fired boiler. Specifically, it is used to keep the pool and boiler water separate while providing an efficient means to transfer heat between the two systems.
MIT swimming pool heat exchangers are fully constructed with pressurized shell and spiral corrugated inner tube. This ensures high velocities inside the unit that makes swimming pool heat exchanger very reliable, efficient and cost effective way to transfer heat indirectly between any hot water circuit, steam circuit and any pool or spa circuit. REV - Swimming pool - Shell & Tube - Heat exchangers unique 3-pass tube bundle enables better utilization of the heat source and creates exceptional heat exchange results. high speed flow on shell side (pool water) titanium versions suitable for salt water pools. corrugated tubes increase flow turbulence which further intensifies heat exchange.
Swimming pool heat exchangers - Shell & Tube (316L Stainless Steel & ium) Among the most common uses of Brazetek ST and STX series shell & tube heat exchangers is heating the swimming pool water. The process presents several challenges, with each one being successfully addressed by Brazetek. For a complete list of Brazetek Swimming Pool Heat Exchangers click here. Brazetek Shell & Tube Heat Exchangers, Swimming Pool ST series are 316L stainless steel shell and tube heat exchangers. STX series are titanium shell & tube heat exchangers. Both types are fully-welded and can be utilized in a variety of applications. ium heat exchangers are commonly used in marine applications such as salt water or others where corrosive liquids are present.
Your email address will not be published.*